CO₂ Systems Solutions

Transcritical CO₂ systems cover a range of 2, 4 and 6-cylinder compressors and 6, 2 to 38.2 m3 / hr (50 Hz) sweep volume. Compressors are distinguished by high reliability, excellent operating performance, a wide frequency band for minimum partial load needs and efficiency standards previously unavailable in the market.

These exclusive standards have also been approved through ASERCOM (European Refrigeration Component Manufacturers Association). Therefore, compressors contribute to the lowest life cycle costs and comply with long-term legal requirements such as the F-gas regulation in Europe.

Compressors are used in transcritical applications for supermarkets, industrial refrigeration and heat pumps.

It covers the sweep volume range of 1.6 to 48.2 m3 / h (50 Hz) for low temperature applications. This series offers the advantages of a compressor series optimally adapted to CO₂ demands.Compressors are used in booster or cascade systems in supermarket and industrial refrigeration applications.

Today, CO₂ is considered a standard solution when a supermarket chain is developing new projects. Political economic environmental and thermodynamic advantages have made CO₂ utilization superior to others in most cases. Thanks to the progress made in recent years, CO₂ is one of the most affordable and available green solutions available on the market today.

iProRACK

iProRACK standard refrigerants are designed for CO₂ subcritical application and IGK and parallel compression CO₂ transcritical booster application. The application can manage two-circuit systems consisting of 12 compressors in each circuit. In transcritical applications, direct high pressure valve heat recovery systems can be controlled by-pass valve and parallel compression.

Subcritical systems are optimized for heat recovery and parallel compression booster solution. These controllers increase the energy saving of the facility while providing a high level of technology thanks to the special algorithms developed.

ECA CO₂ series ball valves are specially designed for CO₂ applications and their production and testing specifications are the same as for standard ball valve systems. Sealing is provided by special elastomers due to the CO2 fluid passing through it. In addition, there are two different nominal pressure options as 45 bar and 120 bar. The 120 bar option is designed for use in transcritical systems and the 45 bar option is designed for use at low pressure levels in both types of systems. In such applications, it is produced with special copper pipe (K-65) or stainless steel pipe according to demand.

ECA CO₂ Series Safety Valves are designed for CO₂ cooling systems. If there is an increase in pressure in the system or if the set pressure value is exceeded, the safety valve opens automatically and safety is provided. After a little fluid is discharged, the valve closes again as the pressure in the installation decreases.

CO₂ Series Engine Controlled valves are used for heat recovery in CO₂ systems or by-pass of gascooler equipment. They can also be used to produce hot gas for defrosting. Motorized valve types are divided into two and three-way.

These types of valves are used to separate sections and add refrigerant when maintenance is required in refrigerant systems. They provide easy closing, filling and emptying of the system. Sealing is provided by double o-rings and in case of high pressure, the tightening nut fixes the shaft safely. 100% of the production is tested with the Helium Detector.

The service valves used to separate one equipment from another in any system in which liquids or gases circulate are of two types : Schrader type and shaft type service valves.

CO₂ Series Service Valves are specially designed to control the necessary parts in the maintenance process in systems using CO₂ fluid.